Printed specs from woofersetc.com:
2 -channel amp
Stereo, 4 ohms: 2x150 Watts
Stereo, 2 ohms: 2x300 Watts
Stereo, 1 ohms: 2x600 Watts
Bridged, 4 ohms: 1x600 Watts
Bridged, 2 ohms: 1x1200 Watts
T.H.D. + Noise: <0.014%
Frequency Response: 20Hz - 20kHz; +0 dB/-0.32 dB
S/N Ratio: >100dB
Transient Distortion: <0.007%
Slew Rate: >32V/uS
Damping Factor: >1000
Input Voltage: 1-4 Volts or 4-16 Volts
Dimensions: 17.5"L x 8.75"W x 2.375"H
For full details from Zapco's website:: http://www.zapco.com/prod/comp_prods/c2k60Frame.htm
or
C2K_Contents_Manual_B.pdf
Here's the story.
My friend was using it and then the sound went
out with protection light. Sent it to Zapco and paid for Robert to
fix it (new power terminal as well). There were some transistors
that needed replacement on the right channel. When I got it back,
I hooked it up to verify operation which now works normally. My friend
since replaced this amp with something else. I wish could use it
but I'm already setup with my TRU Steel amps and I also can't make it fit
in my amp rack.
I also had them do a power test which is down below on
the packing slip.
(392 Watts/Ch. at 2 Ohm Stereo. 784 Watts at 4 Ohm mono.)
There are some scratches as you can see from the pics
below but nothing major.
The 1' RCA to DIN cable (SLRCM.01) purchased from Zapco
also included.
Asking $540 shipped SOLD
to Cont. USA via UPS or FedEx ground.
Payment via Paypal and shipped to Paypal verified address only.
Please contact me if interested.
Thank you.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|